FUNDAMENTAL STUDY ON ELECTRONIC MEDICATION TECHNOLOGY
In depth study of Electronic Medication technology was in fact started due to some weaknesses in the use of modern technology in medical industry . The following issues being the fundamentals study towards the research of the electronic medication technology.
|
Basic Energy
Study on conventional technology showed that matter (mass) was used as a source of energy. The basic of this technology is closely related with the “Theory of Relativity” as defined by Albert Einstein. Energy is defined as e = mc² means that if a mass ( m ) can be converted into energy ( e ) would equal the mass times the square of the speed of light (c ) 3 x 10 billion cm/sec.
|
|
It proves that energy exist with the presence of mass. The theory is partly acceptable because e = mc² is only applicable, if the particle has mass but what happen to the microscopic particle like proton that has no mass.
|
|
Another physic expert Max Planck derived a formula stating that energy can be produced by ‘microscopic particle’ – His famous Max Planck’s Constant formula shows that e = hf. Prof Dr. Sir Amir Hamzah Abdul Hamid extended both the theories to arrive a new formula :e = mc² = hf
The new formula defined energy can be produced without the characteristic presence of substance (mass).
|
|
Mechanism of electronic medication The concept of electronic medication is similar to the radio wave technology. In radio wave transmission the wave energy patterns are transmitted in air and the radio set or television set will act as a receiver and simultaneously change the energy wave to voice or image on a television which we can see and listen. In electronic medication the energy wave produced will be transmitted into two ways namely Constructive Wave Interference and Destructive Wave Interference. In order to better understand how waves interfere with one another. Consider a pair of waves from the same source that are traveling in direction D, as illustrated below. If the vibrations, which are perpendicular to the propagation direction as represented by C, are parallel to each other and are also parallel with respect to the direction of vibration, then the light waves may interfere with each other.
However, if the vibrations are not in the same plane or vibrating at 90 degrees to each other, then they cannot interfere with one another. Constructive Wave Interference In this method the wave energy is utilized for activating the function of the human organ or vitalizing energy vitamins which is required by the body, this is done by increasing the energy signal pattern.
|
|
Assuming all of the criteria listed above are met, then the waves can interfere either constructively or destructively with each other. If the crests of one wave coincide with the crests of the other, the amplitudes of the waves are additive. Thus, if the amplitudes of both waves are equal, the resultant amplitude is doubled. It is important to remember that wave intensity varies directly as the square of the amplitude. Thus, if the amplitude of a light wave is doubled, its intensity is quadrupled. Such additive interference is demonstrated above and is known as constructive interference.
In this method the wave energy is utilized for activating the function of the human organ or vitalizing energy vitamins which is required by the body is done by increasing the energy signal pattern. Once again Newton’s Third Law of Motion is applied but in a constructive manner, this means both waves meet and they will create the increase of resultant wave which is optimized for activating the human organs. In Destructive Wave Interference , if the crests of one wave coincide with the troughs of the other wave, the resultant amplitude is decreased, as illustrated below. This destructive interference is accompanied by a decrease in wave intensity and may even result in a total cancellation of waves occur.
|
|
In this method the energy wave is used to treat any type of diseases. The mechanism behind is cancellation of energy waves. For example when two waves of energy signals which have the same frequency and same amplitude, but out of phase (180 degrees) the result will be cancellation of signals. In this process any diseases can be treated and eventually the patient will progress for total cure.
Damping Off
This process can be explained below, where 0 refers to state of health or cure, at the –ve area explained the state of illness (disease), and +ve is a medicine (cure) area. According to conservative theory of electro magnetism, they will pull inside together if different side of –ve and +ve and if same side will pull aside is half correct. This is due to certain situation. If it is same side of –ve or +ve charge, the above does not happen. The equilibrium must exist first and willingness to allow the pulling in and pulling out to be happened borrowing the –ve charge to be react with +ve charge (cure/medicine be treated first). In treatment of disease the process can be explain below where 0 (equilibrium) willing to allow the –ve (disease) charge to be borrowed to –ve charge (cure) resulting the damping off process towards equilibrium (Healthy state). That means the cure (medicine) must be treated first in order to treat the disease.
|
|
Substance based medicines such as allopathic drugs, Herbs, Ayurvedic and Homeopathic remedies (below Avogadro number, < 6.02 x 10−²³) etc, will be processed and absorbed at the small intestine in the digestive system. The medicine will be circulated in the blood circulatory system to the receptor site. The effectiveness of the medicine is depending on the dosage taken. Non-substance base medicine such as Electronic Medication (above Avogadro number, > 6.02 x 10−²³) will not follow the above processes.
|
|
OVERVIEW OF ELECTRONIC MEDICINES
According to big bang theory the universe was formed through a big explosion that created mass, energy and free radical electrons. Explosions usually are destructive but not for our universe. It is a controlled explosion by the God as the creator of the universe. This explosion then provided energy to the sun and stars. The sun as a black body act as a focal point e1 radiated the energy to the universe and creating other focal point e2, e3 and so on. The plant absorbed the light energy from the sun and convert to chemical energy called glucose. Some chemical energy then passed through to the animal and man when they ate this plant stuff. Then this chemical energy again changed to another forms of energy as kinetic and heat in animal body. The man then reradiates the thermal energy in waves form.
According to kinetic theory, all substances contain atoms or molecules which permanently vibrating. This vibration will create electromagnetic energy pattern with a fixed frequency. So everything in nature emits electromagnetic radiation that is a function of its temperature, and not (in theory) a function of what it is made out of. That radiation is what we call thermal radiation.
In the case of real world substance, what it is made out of does make a difference, and nature expresses that difference by a sort of efficiency; some elements will emit more thermal radiation, even though they are at the same temperature as some other element. High emissive material emits more thermal radiation, and low emissive material emits less thermal radiation, at any given temperature.
Timothy J. Thompson, What is emissivity, Advanced space borne thermal emission and reflection radiometer
The electronic medicine acts like a black body at a focal point then reradiate this thermal energy in infrared wave form with certain emission. This heat energy will be radiated as electromagnetic wave in infrared spectrum range, so that the wave can be used to cure a disease.
“Unlike visible light, infrared light is emitted by any object that has a temperature above absolute zero K."
John Merchant, 2004. Infrared temperature measurement Theory and application.
"Every unique molecule has its own characteristic frequency of vibration. So, unlike a blackbody emitter, molecules emit energy that depend on Planck’s distribution."
http://tes.asu.edu/MARS_SURVEYOR/MGSTES/TES_emissivity.htm
APPLICATION OF ENERGY WAVE IN ELECTRONIC MEDICATION
In physics, reference to the “Law of Resonance & Dissonance” of energy wave concept can be applied in treating diseases. Application of energy wave in electronic medication to combat diseases can be defined as follows: Law of Dynamism defined that in a dynamic state, all particles vibrate and we termed it as ‘Simple Harmonic Motion’. The wave energy pattern form can be recorded , digitally coded and can be used to prepare various digitally coded remedies in combating diseases.
Coding of energy wave
Mathematically, it is proven that every particle (mass) has its wave duality. So, by using technology of “ Law of Resonance”, coding of wave energy of particles become possible.
In order to cure, the digitally coded remedy or artificial disease wave must be stronger than the natural disease wave with phase difference of – 180 degrees and slightly longer in terms of its wavelength (minimum ½).
Application of ‘resonance’ technology, proves that energy wave is created without the use of particle. This energy wave can be made stronger or destructive without involvement of any particle.
|
